Henrys Pirouette Juggling Club Body (Replacement Shell)

Revive, repair, or custom-build your juggling setup with genuine Henrys Pirouette Club Bodies. Whether you need to replace a cracked, worn-out shell or want to construct your own custom Pirouette or short-handle Delphine club from scratch, these official factory-made bodies deliver the identical balance, weight, and durable performance you expect from Henrys.

Key Features & Specifications

• Authentic Henrys Craftsmanship: Designed for seamless fit, consistent spin dynamics, and long-lasting durability under heavy drop impact.

• Two Finish Options: Available in both Standard Smooth and Tactile Grip textures to match your preferred catch surface.

• Fully Interchangeable: Both smooth and grip body options fit standard and grip Pirouette variants flawlessly.

Component & Handle Compatibility

These replacement bodies are fully compatible with a wide range of Henrys and Play component parts:

• Handles: Henrys Pirouette handles and Henrys Delphine (Short version) handles. (Note: Not compatible with long-handle Delphine variants).

• Caps & Tips: Henrys Colored Flat Tips, Henrys Delphine Flat Tips, PX3/PX4 Play High End Caps, and PX3/PX4 High "Equi" Tips.

Translucent "Vision" DIY Edition

For custom glow setups, select translucent bodies are specially designed for DIY integration with Flowtoys Vision electronic components.

• Assembly Note: Certain translucent bodies arrive pre-drilled for Vision hardware. Other batches require manual top-hole preparation using a hole saw (not included). Recommended for jugglers with DIY experience.

Step-by-Step Maintenance & Repair Guide

Replacing your club shell takes only a few minutes with basic tools:

1. Disassembly: Using a Phillips-head screwdriver, unscrew the top cap screw and set it aside. Carefully remove the existing tape wrapping the central joint, then slide the old body off the internal dowel.

2. Fitting: Slide the new Pirouette body into position over the wooden dowel until it rests flush against the handle seam.

3. Re-Taping: Securely seal the central handle-to-body joint using premium-grade electrical or decorative tape. Pro Tip: Always use high-quality vinyl tape that resists adhesive bleed and melting under direct sun or heat.

4. Reattaching the Top Cap: Place the top cap back on and re-fasten the original screw.

Expert Maintenance Tip: Fixing Stripped Screw Holes

Crucial Rule: Always re-use the original manufacturer screw when reattaching top caps. Henrys engineered screws are high-tensile steel designed to withstand direct ground impact while preserving the internal wooden dowel.

If you are refurbishing an older, heavily used club and find the top cap screw spins freely without biting into the wood:

1. Dip a standard wooden matchstick (or small wooden toothpick) into a dab of quality wood glue.

2. Insert the matchstick directly into the stripped screw hole on the top of the wooden dowel.

3. Trim the matchstick flush with the dowel end, re-insert your original screw through the top cap, and tighten firm.

4. The added wood fiber and glue fill the worn cavity, restoring full thread grip and extending your club's operational lifespan.